Go Back   Chrysler 200 Forum > Chrysler 200 General Discussions > Chrysler 200 Engine & Performance

Chrysler 200 Engine & Performance Discuss Engine and Performance mods for your Chrysler 200 here.

Reply
 
Thread Tools Display Modes
Old 11-19-2016, 06:31 PM   #1
jimmy2
Junior Member
 
Join Date: Nov 2016
Posts: 12
Default not hot

hi guys, just took my wife's 2012 200 out for a ride (shopping) and it wouldn't get above 1/4 in temp gauge, the outside temp was about 33' and winds were at about 40 mph. I checked it out when I got home and the reservoir was full, no hoses leaking but the hoses felt soft. opened cap on the coolant tank and it did have some pressure behind it. I also found a bleeder on the thermostat and opened it up while it was running and coolant did come out. in the garage the temp did rise to almost 1/2 point. is it normal for the 3.8 v6 to do that? my only thought would be a stuck thermostat in the open position. anybody have this happen and what was it? thanks a lot for your input!!
jimmy2 is offline   Reply With Quote
Old 11-26-2016, 11:50 PM   #2
jimmy2
Junior Member
 
Join Date: Nov 2016
Posts: 12
Default

update... thermostat replaced, pia to get to bottom bolt, nothing looked bad added new one everything is fine!!! rechecked old thermostat found pin to be VERY HARD to move, thought on this, it would open but not at right temp(colder) then would not close at all after that!
jimmy2 is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:29 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.