Go Back   Chrysler 200 Forum > Chrysler 200 General Discussions > Chrysler 200 Wheels, Tires & Supension
FAQ Community Calendar Today's Posts Search

Chrysler 200 Wheels, Tires & Supension Discuss Wheels, Tires, & Suspension for the Chrysler 200 here.

Reply
 
Thread Tools Display Modes
Old 12-15-2013, 05:35 PM   #21
SGIFL
Junior Member
 
Join Date: Oct 2013
Posts: 6
Default

Mine Fixed Tallahassee DCJ replaced both front stabilizer links. Did a two thousand mile run and no NOISES.
SGIFL is offline   Reply With Quote
Old 07-24-2014, 11:50 PM   #22
Carol
Junior Member
 
Join Date: Jul 2014
Age: 76
Posts: 1
Angry 2012 Chrysler 200S Front End Noise

I started hearing a noise in the front end within a week of purchase, had the car back to dealership 3 times. Finally it was bad enough they found the steering rack was bad, only showed up if I drove the car for 30 mins before taking to dealership.
One month later, noise is back. They had to replace the tie rods ends (second set), changed the first set when they did the steering rack.
One week after I got the car back the noise is back and now I am having problems with it pulling to the right and steering wheel shaking. I think Chrysler needs to look into this problem, dealership said it was bad parts from the supplier but don't think all of this should happen on a car with only 20,000 miles.
Carol is offline   Reply With Quote
Old 02-10-2015, 12:39 AM   #23
iammeiamfree
Junior Member
 
Join Date: Feb 2015
Posts: 1
Default

I am driving a 2013 Chrysler 200. I am also hearing that clunking noise. Not all the time, but I hear it mostly when I am making a turn or, like the others, when driving on a bumpy road or going over speed bumps.

Can anyone tell me or does anyone know- that if I take the car into the dealership, is this an issue that would be covered under the warranty? We have about 46000 miles on it- so we only have a few hundred more miles on our car before the warranty is up.
iammeiamfree is offline   Reply With Quote
Old 07-07-2015, 07:47 PM   #24
JP_200_Limited
Junior Member
 
Join Date: Jul 2015
Posts: 1
Default

I am currently dealing with this same front end clunking issue. I will be making my 3rd appearance at the dealership later this week. It started ever so slightly at the end of last summer between 40-50k miles, and went away in the winter, but now its back louder than ever this summer.

Symptoms are as follows:

You never hear a sound during the winter (or basically below 40-50 deg. weather) As soon as the season changes and warms up and you drive the car ~20 to 30 miles/minutes you hear a clunk about every 10 feet or so (or more on uneven pavement or bumps). The clunk can be felt in the steering. The audible noise is coming predominantly from the front left/center (more left than center) of the vehicle.

It seems that the entire engine compartment must be brought up to temperature before the problem announces itself. I have taken 2 service reps for a drive, and both times they nodded and agreed that its completely annoying and clunking like crazy. Then, they take the car out back, park it for 3 hours until someone can work on it..... and the car cools down, stops making the noise because its cooled..... and the technicians put it on the hoist and poof, they say nothing is wrong....

Apparently, they have to confer with the service rep to explain what they think is wrong... and since neither of them really knows whats wrong, they just agree to throw some parts on it and test drive it for 30 seconds around their parking lot and call it fixed. I even told them to drive the car --- PLEASE drive the car for 30 mins --- the gas is on me!.... both times they said it was fixed and both times a 30 minute drive proved otherwise.

So far, I have gotten a free lower control arm, free torsion stabilizer sway link or something, and some more work done on the right rear (when the noise was coming from the front) They recommended an alignment, and Chrysler threw that in for free ($150 bux) and the clunk has not even remotely stopped happening.

Even if they fix this, which I know will only be a Band-Aid fix, I will not buy another 200 again, this drive train is junk. It makes more creeks, groans, thumps and noises than a 150 year old haunted house in a hurricane.

I am now looking at Jeeps

Last edited by JP_200_Limited; 07-07-2015 at 07:59 PM.
JP_200_Limited is offline   Reply With Quote
Old 09-10-2015, 10:29 AM   #25
Boblcraft
Junior Member
 
Join Date: Sep 2015
Posts: 2
Default Front End Issues

I had two Chyrsler Sebrings'- 2009 Limited Hardtop Convertible and a 2010 Sedan Touring. The 2009 convertible started the clunking sound on the driver's side at about 2000 miles. The dealer replaced the CV joint, struts and finally the rack and pinion. It corrected it for about 3000 miles and the noise returned. The dealer replaced the rack and pinion for a second time and it corrected the problem. I subsequently drove the vehicle to 141,000 miles and no noise. The 2010 Sedan started the noise at about 40,000 miles and although we had experience with the 2009 and the same noise the dealer thought it was the driver side CV joint. It correct the noise for about 10,000 miles and the clunking returned. He then still refused to accept the rack and opinion proof and replaced the struts. The noise went away for about 5000 miles then returned. Upon review, the previously replaced CV joint on the driver side started leaking. They replaced the boot. The noise remained until I sold the car at 143,000 miles. My money is on the rack and pinion unit.

Two things strike me- (1) Chrysler HAS TO ABSOLUTELY BE AWARE OF THIS! This is nonsense that they hide from it. (2) The rack and pinion units are almost always on back order according to my dealer.

Last edited by Boblcraft; 09-10-2015 at 11:43 AM.
Boblcraft is offline   Reply With Quote
Old 09-10-2015, 10:41 AM   #26
Boblcraft
Junior Member
 
Join Date: Sep 2015
Posts: 2
Default Front end problem part 2

Not giving up on Chyrlser because of the convertible, I bought a 2012 Limited Hardtop Convertible used with about 20,000 miles. As soon as I started the long drive home a vibration/shimmy (felt more in my seat than the wheel) was pronounced starting at about 60 mph. The more you drove the more annoying. Standard highway surface- nothing out of the ordinary.

I thought it might be a "flat spot" sitting on the lot or alignment. I immediately took it to the dealer and they aligned it and balanced the tires. The problem persisted. They then said it might be a bad tire. I replaced all 4 tires and at their suggestion with the OEM Goodyears. Down the road and the problem is still there! I have it back at the dealer and want them to look at the struts or torsion bar bushings or even a tie rod. It's unacceptable Does anyone have any suggestions as to a corrective action. As soon as I get it back from the dealer I'll post the results but don't have much faith they will fix this.
Boblcraft is offline   Reply With Quote
Old 01-19-2018, 08:08 AM   #27
manualsco
Junior Member
 
Join Date: Jan 2018
Location: Gurgaon
Age: 37
Posts: 1
Default Chrysler Issues

You should download Chrysler repair manuals, workshop manuals and wiring diagram.
manualsco is offline   Reply With Quote
Old 04-19-2019, 02:56 AM   #28
Janiece
Junior Member
 
Join Date: May 2018
Age: 36
Posts: 1
Default

So I take it back the next Monday, they keep it until Wednesday. Hey, the visor and map light are in after being on National Backorder (good band name). Ya sold a million cars, how is that? Anyway, after a 60 minute wait and after it cools off long enough to need a 5 minute drive to really get a full throated banging, the svc manager (who is very nice mind you) hears it and he says its a rack and pinion issue, and he will get a new one in. So I leave it, take the shuttle can and go without car for 3 days (now 5 total).
Janiece is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:53 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.